Table of Contents
Advertisement
Menu
15. Fiber Channel
16. PHY Module
17. FC Switch
18. Connection Module
19. Storage Blade
■ Management Agent Information (1_1)
Sets the various agents operating in the Management Blade.
+------------------------------------------+
|
+------------------------------------------+
(1)
Set Management Agent IP Address
(2)
Set Management Agent Network Mask
(3)
Set Management Agent Gateway
(4)
Set Management Agent Default Route
(5)
Set Management Agent DHCP Configure
(6)
Set Time Zone
(7)
Set Management Agent Date Time
(8)
Set Management Agent Timeout(Sec)
(9)
Agent System Info
(-)
Management Agent Administrative URL
(11) Automatically Adjust Clock for Daylight Saving Changes : disable
(12) Agent HTTP
(13) Agent SNMP
(14) Agent Telnet
(15) Agent DNS
(16) Agent SMTP
(17) Agent NTP
(18) Agent NIC Duplex Mode
(19) Change Management Role To Slave
Enter selection or type (0) to quit:
❑: Parameter
Parameter
1. Set Management Agent IP
Address
2. Set Management Agent
Network Mask
3. Set Management Agent
Gateway
4. Set Management Agent
Default Route
5. Set Management Agent
DHCP Configure
6. Set Time Zone
PRIMERGY BX600 Management Blade Hardware Guide
Displays the status of the FC Pass-Thru Blade.
"■ Fiber Channel (1_15)" (p.125)
Displays the status of the GbE Pass-Thru Blade.
"■ PHY Module (1_16)" (p.127)
Displays the status of the FC Switch Blade.
"■ FC Switch (1_17)" (p.129)
Not normally used.
Displays the status of the Storage Blade.
"■ Storage Blade (1_19)" (p.130)
Agent Information
page_1_1
: 192.168.1.1
: 255.255.255.0
: 0.0.0.0
: LAN
: disable
: (GMT+9)
Osaka, Sapporo, Tokyo
: MM/DD/YYYY HH:MM:SS
: 900
: http://192.168.1.1:80/
Setting
(setting required)
Sets the IP address of the Management Blade. Settings
become valid after restarting the Management Blade.
(setting required)
Sets the subnet mask of the Management Blade. Settings
become valid after restarting the Management Blade.
-
Sets the gateway of the Management Blade. Settings
become valid after restarting the Management Blade.
-
Not normally used. Set to LAN.
❑
enable
Sets whether to set the IP address, subnet mask and gateway
❑
disable
of the Management Blade from the DHCP server. Settings
become valid after restarting the Management Blade.
-
Sets the time zone of the Management Blade. Supports the
time zone table.
Description
|
Contents
71
Advertisement
Table of Contents
