PRIMERGY BX600 S3 Hardware Manual page 115

■ Event Log (1_8)
Checks event logs related to Management Blades and Server Blades.
+------------------------------------------+
|
+------------------------------------------+
(1) Management Blade Event Log
(2) Server Blade Event Log Table
(3) Server Blade Power On/Off Event Log Enable : disable
(4) Management Blade Wrap Around Event Log Enable : enable
Enter selection or type (0) to quit:
❑: Parameter ❍: Setting at time of purchase
Parameter
1. Manage Blade Event Log
2. Server Blade Event Log Table
3. Server Blade Power On/Off
Event Log Enable
4. Management Blade Wrap
Around Event Log Enable
PRIMERGY BX600 Management Blade Hardware Guide
Event Log page_1_8
Setting
- Checks the log of the Management Blade.
- Checks the logs of the Server Blades installed in the
chassis.
"● 2. Server Blade Event Log Table" (p.116)
❑
enable This is set whether power ON/OFF and shutdown of the
❑
disable Server Blade is recorded in a Management Blade event
log.
Important:
If set to "enable", the number of event logs
registered increases. Pay attention to the
remaining number of event logs and make
sure not to exceed the maximum.
❍
enable Sets the log operations when the number of Management
❑
disable Blade event logs has maximized.
• enable
When the number of event logs has maximized, logs
are overwritten in order from the oldest.
• disable
Stops log operations when the number of event logs
has maximized.
|
Contents
115