Table of Contents
Advertisement
Chapter 2 Installing and Removing Management Blades
2.3 Default Settings
Before using the Management Blade, some default settings must be performed.
2.3.1 Management Software
Management Blade supports management tools such as Web UI (web user interface) and CLI (command
line interface). Using these management tools, the chassis of the blade server and various blades can be
easily managed from the management terminal.
• The Web UI operates/manages using the Web browser via the LAN.
• CLI operates/manages using a command line base on the console menu that uses serial ports or Telnet
protocol via LAN.
2.3.2 Communication Interface Settings
Perform the necessary settings from among the following depending on the management tools and
method of communication to be used.
• When using Web UI or CLI via Telnet
"■ LAN Interface Settings" (p.16)
• When using CLI via a serial interface
"■ Serial Interface Settings" (p.18)
Access the various management tools using the user name "root", password "root" as set in the default
user settings during default settings. Password is case sensitive.
■ LAN Interface Settings
The procedures for settings LAN interface are as follows.
The LAN interfaces of Management Blade can be set to 10Mbps full duplex/ 10Mbps half duplex/
100Mbps full duplex/ 100Mbps half duplex/ auto-negotiation. Set the same setting to the connecting
hub. If they are connected in different settings, the level of communication efficiency may severely
decrease or communication may fail.
16
Advertisement
Table of Contents
