ADJUSTMENTS DURING THE EMBROIDERY PROCESS
ADJUSTMENTS DURING THE
EMBROIDERY PROCESS
If the Thread Breaks or the Bobbin
Runs out of Thread During
Embroidering
a
Redo the upper threading or replace the bobbin.
If the upper thread breaks, stop the machine, trim the
bobbin thread, and then rethread the machine.
If the bobbin thread is almost empty or broken, press
of the displayed message, remove the embroidery
frame, and then replace the bobbin.
Note
• If [Upper and Bobbin Thread Sensor] in the settings
screen of the machine is set to [OFF], the message
shown above does not appear.
b
Press
.
c
Press
,
back the correct number of stitches before the area
where the thread broke, and then press
• Press
to restart from the beginning.
66
,
, or
to move the needle
Note
• It is recommended to stitch over the top of the last
two or three stitches for complete coverage.
Memo
• If you cannot move back to the spot where the
thread broke, press
and move to the beginning position of that color,
then use
to slightly before where the thread broke.
d
Lower the presser foot and press the "Start/Stop"
button to continue embroidering.
.
or
to select the color
,
,
, or
to move ahead