Scale Menu - Anritsu MS2024B Manual

7-5 Scale Menus

Scale Menu

This menu has only three soft keys when Display Type is set to Single. An additional soft key
is displayed when Display Type is set to Dual or Overlay.
Scale Menu – Single
Start Freq: Press this soft key to set the start frequency in units of Hz, kHz,
MHz, or GHz. If you enter a start frequency that is higher than the
Scale
currently-set stop frequency, and if CAL = On, then the start frequency is set
Top
to the same value as the stop frequency. If you enter a start frequency that is
higher than the currently-set stop frequency, and if CAL = Off, then both start
# dB
and stop frequency are set to the new frequency.
Bottom
Stop Freq: Press this soft key to set the stop frequency in units of Hz, kHz,
MHz, or GHz. If you enter a stop frequency that is lower than the currently-set
# dB
start frequency, and if CAL = On, then the stop frequency is set to the same
value as the start frequency. If you enter a stop frequency that is lower than
the currently-set start frequency, and if CAL = Off, then both stop and start
frequency are set to the new frequency.
Center Freq: Press this soft key to set the center frequency in units of Hz,
Autoscale
kHz, MHz, or GHz. The center frequency can be set with the arrow keys, the
rotary knob, or the number keypad. When using the number keypad, the
menu displays soft keys with Hz, kHz, MHz, and GHz units. Pressing the
Enter key has the same effect as pressing the MHz soft key.
Span: Press this soft key to set the span in units of Hz, kHz, MHz, or GHz.
The span setting determines the frequency range over which the instrument
sweeps. The span may be set from 0 (zero) to the maximum frequency of the
instrument.
Figure 7-9. Field View Scale Menu – Single Display Type
7-10 PN: 10580-00289 Rev. K
Field View Menus
Vector Network Analyzer MG