Calibration Menu - Anritsu MS2024B Manual

7-8 Calibration Menu

7-8 Calibration Menu
To access the Calibration Menu, press the Shift key, then the Calibrate (2) key.
Calibration
Start Cal: Press this soft key to open the "Next Step" List Box, which contains
Start Cal
the instructions: "Connect cal component, select step, and press Enter to
measure:"
Cal Type
Cal Type
2-Port 1-Port: Press this soft key to toggle the calibration type to 1-Port or
2-Port 1-Port
2-Port.
Existing Cal Info: Press this soft key to open the
Existing Cal Info
Information List Box" on page
Cal Correction
Cal Correction
On Off: Press this soft key to toggle calibration correction On and Off.
On Off
Figure 7-20. Calibration Menu
7-9 Existing Calibration Information List Box
Figure 7-21. Existing Calibration Information List Box
The Existing Calibration Information list box shows the various sweep setting types for the
active calibration and compares this information to the current sweep settings. It also
displays the Cal Status information and the associated level of accuracy.
7-18
7-18. Press Enter or Esc to close the list box.
PN: 10580-00289 Rev. K
Field View Menus
"Existing Calibration
Vector Network Analyzer MG