Distance Setup Menu - Anritsu MS2024B Manual

VNA View Menus

Distance Setup Menu

Preliminary Key Sequence: Measure > Domain Selection > Distance
or
Preliminary Key Sequence: Freq/Time/Dist > Domain Setup > Setup Distance
Key Sequence: Freq/Time/Dist
Distance Setup
Start Dist: Press this soft key to set the start distance. Use the arrow keys,
the rotary knob, or the number keypad to set a distance value. When using
Start Dist
the number keypad, the menu displays soft keys with meters (m),
# mm
centimeters (cm), or millimeters (mm) as units. Pressing the Enter key has
the same effect as pressing the meter (m) soft key. If the Application Options
menu is used to set units in feet rather than meters, the distance settings are
Stop Dist
in feet (ft) only, and pressing the Enter key sets the units to feet.
# m
Stop Dist: Press this soft key to set the stop distance in meters (m),
centimeters (cm), or millimeters (mm). If the Application Options menu is
Start Freq
# kHz used to set units in feet rather than meters, the distance settings are in feet (ft)
only.
Start Freq: Press this soft key to set the start frequency in units of Hz, kHz,
Stop Freq
# GHz
MHz, or GHz.
Stop Freq: Press this soft key to set the stop frequency in units of Hz, kHz,
Windowing
MHz, or GHz.
Nominal Side Lobe
Windowing: Press this soft key to open the
shape value is displayed on the key face, and may be Rectangular, Nominal
Additional Dist Setup
Side Lobe (as in this example), Low Side Lobe, or Minimum Side Lobe.
Additional Dist Setup: Press this soft key to open
Menu (Coax)"
Gate
Gate: Press this soft key to open the
Domain Setup: Press this soft key to return to the
The message on the key face reflects the setup feature (Distance) that is in
Domain Setup
use.
Distance
Figure 6-7. Distance Setup Menu
Vector Network Analyzer MG
or the "Additional Dist Setup Menu
PN: 10580-00289 Rev. K
6-3 Domain Setup Menus
"Windowing Menu". The window
the"Additional Dist Setup
(Waveguide)".
"Gate Menu".
"Setup Domain Menu".
6-9