Error Messages
If any of the subtests shows FAILED, then check that the battery level is adequate for
operation or that temperature is within acceptable limits. Reset to factory defaults with
either Factory Defaults (Esc+On), or Master Reset (System+On).
Use of Master Reset (System+On), will erase all user saved setups and
Caution
measurement traces and will return the instrument to a full Factory Default
condition. If the error persists, then contact your Anritsu Service Center.
Application Self Test Results Window — SPA
Figure C-3. Application Self Test Results Window (Spectrum Analyzer mode)
Vector Network Analyzer MG
C-3 Self Test or Application Self Test Error Messages
PN: 10580-00289 Rev. K
C-5