Table of Contents
Advertisement
VNA View Menus
Preset Menu
Preset: Press this soft key to preset sweep conditions to the default state of
full band sweep, 201 data points, Quad display, 4 traces (S
Preset
Mag, S
output power, continuous sweep. This also turns off markers, limits, and
Preset
calibration.
Save: Press this soft key to open a dialog box to name and save the current
operating settings, allowing them to be recalled later in order to return the
Save
instrument to the state it was in at the time that the setup was saved.
Caution: Use the Change File Type soft key (in the "Save (Text Entry)
Menu", refer to the file management instructions in the user guide for your
Recall
instrument) to set the file type to "Setup (with CAL)", if it is currently set to
another file type.
The saved setup is named by entering text. Use the Shift key to select an
upper case letter. Use the Left/Right directional arrows to move the cursor
position. Press Enter to save the setup.
Recall: Press this soft key to open a selection box that allows selection and
recall of a previously stored instrument setup. The Recall menu also opens
(refer to the file management instructions in the user guide for your
instrument). Use the Recall menu soft keys to work within the selection box.
All current instrument settings are replaced by the stored setup information.
Press the Esc key to cancel the recall.
Figure 6-58. Preset Menu
To access the Preset Menu, press the Shift key, then the Preset (1) key. The Preset menu is
used to preset the VNA Master.
Vector Network Analyzer MG
Log Mag, S
Smith), 10 kHz IFBW, S
12
22
PN: 10580-00289 Rev. K
6-7 Measurement Menus
Smith, S
11
Log Mag display, High
21
Log
21
6-59
Advertisement
Table of Contents
