Limit Menus - Anritsu MS2024B Manual

6-5 Limit Menus

6-5 Limit Menus
Figure 6-36. Limit Menus Group
To access the Limit Menu, press the Shift key, then the Limit (6) key.
Two types of limit lines can be specified, lower limit lines and upper limit lines. Limit lines
can be used for visual reference only, or for pass/fail criteria using the limit alarm. Limit
alarm failures are reported whenever a signal is above the upper limit line or below the lower
limit line. Limit lines cannot be used with Smith Chart or Polar graphs.
Each limit line can consist of a single segment, or as many as 40 segments across the entire
frequency span of the instrument. These limit segments are retained regardless of the current
frequency span of the instrument. Limit segments allow the configuring of specific limit
envelopes at various frequencies of interest without having to reconfigure them each time
that the frequency is changed. To clear the current limit setup configuration and return to a
single limit segment (starting at the current start frequency and ending at the current stop
frequency), press the Clear Limit soft key.
6-38
Limit
Active Trace
Tr#
Limit
Upper Lower
Limit State
On Off
Limit Edit
Limit Alarm
On Off
Pass Fail Message
On Off
Clear Limit
PN: 10580-00289 Rev. K
Limit Edit
Move
Point Limit
Limit X
# kHz
Amplitude
#
Add
Point
Delete
Point
Next
Point
Left
Next
Point
Right
Back
Vector Network Analyzer MG
VNA View Menus