Chapter 6-Vna View Menus; Introduction; Vna Key Functions - Anritsu MS2024B Manual

Chapter 6 — VNA View Menus
6-1

Introduction

The menus that are shown in this chapter are found on the Vector Network Analyzer
instrument when it is in VNA measurement view. This guide contains measurement
instructions for the available Vector Network Analyzer instrument options. Not all options
are available on all models, and your instrument may not have all options installed. Refer to
the options sticker on the rear panel or connector panel, or to the User Guide that was
supplied with your instrument to determine which options are installed.
6-2

VNA Key Functions

Introduction
The following list is a quick reference to the principal menus in the Vector Network Analyzer.
For more specific information on a particular measurement, refer to the related chapter for
the measurement being made. The key function menus are presented in the following order:
• "Freq Menu" on page 6-4
• "Setup Domain Menu" on page 6-5
• "Time Menu" on page 6-6
• "Time Info List Box" on page 6-7
• "Windowing Menu" on page 6-8
• "Distance Setup Menu" on page 6-9
• "Additional Dist Setup Menu (Coax)" on page 6-10
• "Additional Dist Setup Menu (Waveguide)" on page 6-12
• "Distance Info List Box for Cable" on page 6-13
• "Distance Info List Box for Waveguide" on page 6-13
• "FGT Menu" on page 6-14
• "Gate Menu" on page 6-15
• "Gate Setup Menu (continued)" on page 6-16
• "Gate Shape Menu" on page 6-17
• "Calibration Menus" on page 6-18
• "Calibration Menu" on page 6-19
• "Existing Calibration Information List Box" on page 6-28
• "Additional Calibration Considerations" on page 6-28
• "DUT Port Setup Menu (Coax)" on page 6-29
• "Cal Kit Definition Menus for Coax" on page 6-30
• "DUT Connector Selector List Box for Coax" on page 6-31
Vector Network Analyzer MG PN: 10580-00289 Rev. K 6-1