Introduction - Anritsu MS2024B Manual

Chapter 7 — Field View Menus
7-1

Introduction

The menus that are shown in this chapter are found on the Vector Network Analyzer
instrument when it is in VNA mode. All of the vector network analyzers that are referenced
in this measurement guide provide the VNA measurements view (as described throughout
this document). Only the MS20xxB VNA Master and the S412E LMR Master provide the
Field measurements view that is described in this chapter.
The following list is a quick reference to the principal Field View menus in the Vector
Network Analyzer. The menus in this chapter are presented in the following order:
• "Field View Menus, Basic Group" on page 7-2
• "Field View Frequency Menu (Frequency-Based)" on page 7-3
• "Field View Frequency Menu (Distance-Based)" on page 7-4
• "Field View DTF Menu Group" on page 7-5
• "Field View DTF Setup Menu" on page 7-6
• "Field view Windowing Menu" on page 7-8
• "Field View Scale Menu Group" on page 7-9
• "Field View Scale Menu – Single Display Type" on page 7-10
• "Field View Scale Menu – Dual and Overlay Display Type" on page 7-11
• "Field View Sweep Menu Group" on page 7-12
• "Field View Sweep Menu" on page 7-13
• "Field View Avg/Smooth Menu" on page 7-14
• "Field View Source Power Menu" on page 7-14
• "Field View Measure Menu Group" on page 7-15
• "Field View Measure Menu – Single" on page 7-15
• "Field View Measure Menu – Dual" on page 7-16
• "Field View Marker Menu" on page 7-17
• "Calibration Menu" on page 7-18
• "Existing Calibration Information List Box" on page 7-18
• "Application Options Menu – Field versus VNA" on page 7-19
7-2 Field View Menus
The Field View Menu Group is shown in
Vector Network Analyzer MG
Figure 7-1 on page
PN: 10580-00289 Rev. K
7-2.
7-1