Chapter 5-Field Measurements; Introduction; Options; Field Measurements View Setting - Anritsu MS2024B Manual

Vector network analyzer for anritsu rf and microwave handheld instruments
Hide thumbs Also See for MS2024B:
Table of Contents

Advertisement

Chapter 5 — Field Measurements
5-1

Introduction

This chapter describes some of the VNA measurements that can be made with the Field
measurements view. It includes the differences between VNA measurements view and Field
measurements view.
All of the vector network analyzers that are referenced in this measurement guide provide
the VNA measurements view (as described throughout this document). Only the S412E
LMR Master and the MS2024B, MS2025B, MS2034B, MS2035B (MS20xxB), VNA Master
provide the Field measurements view that is described in this chapter.

Options

The Vector Network Analyzer instruments can be configured with VNA options: Bias Tee
(Option 0010), Vector Voltmeter (Option 0015), and 6 GHz VNA Frequency Extension
(Option 0016). Only the S412E LMR Master requires Option 16.
The LMR Master standard frequency range is 500 kHz to 1.6 GHz. Option 0016
Note
extends this range to 6 GHz in VNA mode.
5-2

Field Measurements View Setting

The Measure menu can be changed between two different settings, Field or VNA. For users
already familiar with the Anritsu Site Master measurement nomenclature, the Field
measurements view setting will likely be more comfortable. The VNA measurements view
setting is designed to more closely resemble the menus of a bench top VNA, and allows access
to more advanced features of the Vector Network Analyzer.
The VNA measurements view is the default presentation throughout this manual. This
chapter, however, provides the subset of measurements and menus that are specific to the
Field measurements view.
Select Measurement Type – Field versus VNA
Change between the Field measurements view and the VNA measurements view by pressing
the Shift key followed by the System (8) key, and then by pressing the Applications Options
soft key (submenu key). Press the Meas Menu soft key to toggle between Field and VNA.

Touch Screen Trace Features

Refer to section
"Touch Screen Trace Features" on page

Markers on a Touch Screen

Refer to section
"Markers on a Touch Screen" on page
Vector Network Analyzer MG
2-8.
PN: 10580-00289 Rev. K
2-3.
5-1

Advertisement

Table of Contents
loading

Table of Contents