Limit Menu - Anritsu MS2024B Manual

VNA View Menus

Limit Menu

Active Trace: Press this soft key to open the "Active Trace Selector" List Box
and select a trace. The selected trace number is displayed on the soft key
face. Scroll through the list with the arrow keys or the rotary knob, and press
the rotary knob or the Enter key to select a trace. Press the Esc key to cancel
Limit
and close the list box without changing the previously-selected trace.
Active Trace
Limit
Tr#
Upper Lower: Press this soft key to toggle the active limit to be the upper
or lower limit. The limit line that is currently selected for editing is underlined
on the soft key face.
Limit
Upper Lower
Limit State
On Off: Press this soft key to toggle the Limit State On and Off.
Limit State
Limit Edit: Press this soft key to open the
On Off
Menu"
multi-segment limit lines. The currently active limit point is marked by a red
circle on the measurement display.
Limit Edit
Limit Alarm
On Off: Press this soft key to toggle the Limit Alarm On and Off. For the
Limit Alarm
currently-active limit line, this soft key determines whether an alarm beep
On Off
occurs when a data point exceeds the limit.
Pass Fail Message
Pass Fail Message
On Off: Press this soft key to toggle the Pass Fail Message feature On and
On Off
Off. The message indicates "FAIL(Up)" and "FAIL(Low)" for upper and lower
limit failures, and it indicates "PASS" for passing measurements. The pass
and fail messages are displayed in the same color as the measurement trace.
If more than one trace is displayed in a single measurement display window,
the message color helps distinguish the trace with which the message is
associated.
Clear Limit
Clear Limit: Press this soft key to delete all limit points for the currently
active limit line. A segmented limit line changes to the default, which is a
single limit whose amplitude value is adjusted to make it visible in the sweep
window. The other (non active) limit line is not altered.
Figure 6-37. Limit Menu
Vector Network Analyzer MG
has soft keys for the creating or editing of single limit lines or
PN: 10580-00289 Rev. K
6-5 Limit Menus
"Limit Edit Menu". The "Limit Edit
6-39