C-1 Introduction - Anritsu MS2024B Manual

Appendix C — Error Messages
C-1 Introduction
This appendix provides a list of information and error messages that could be displayed on
the test instrument. If any error condition persists, then contact your local Anritsu Service
Center.
C-2 Reset Options
You can reset your instrument to Factory Defaults or use a Master Reset to return to the
FULL Factory Default condition from the menu system or from the Off condition.
Reset Via Instrument Menus
From the instrument menu system, press the Shift key, then the System (8) key to open the
System menu. Then press the System Options soft key to open the System Options menu.
Then press the Reset soft key to open the Reset menu (refer to your user guide). From the
Reset menu, press either the Factory Defaults soft key or the Master Reset soft key.
Reset from OFF Condition
You can also reset the instrument by turning it Off and then restarting under one of the
following conditions:
Factory Defaults Reset:
Hold the Esc button while pressing the On/Off button. Continue holding the Esc button until
the Anritsu splash screen appears. You can then release the button. The instrument starts up
with many Factory Default settings (refer to your user guide). Throughout this appendix, this
sequence is abbreviated as Factory Defaults (Esc+On).
Master Reset:
Hold the 8 key in the number keypad (also referred to as the System (8) key) while pressing
the On/Off button. Continue holding the 8 key until the Anritsu splash screen appears. You
can then release the key. The instrument starts up in FULL Factory Default condition (refer
to your user guide). Throughout this appendix, this sequence is abbreviated as
Master Reset (System+On).
Vector Network Analyzer MG PN: 10580-00289 Rev. K C-1