Gate Setup Menu (Continued) - Anritsu MS2024B Manual

6-3 Domain Setup Menus

Gate Setup Menu (continued)

Gate
Center Gate: Press this soft key to set the center Gate in either time or
distance units, depending on whether the active trace is in the Time Domain
Gate Function
or the Distance Domain. In time domain, the units are in seconds (s),
Off Display On
milliseconds (ms), microseconds (µs), nanoseconds (ns), or
picoseconds (ps). In distance domain, the units are in meters (m),
centimeters (cm), or millimeters (mm). If the
Start Gate
Mode)"
# ns
settings are in feet (ft) only.
Span Gate: Press this soft key to set the span Gate in either time or distance
Stop Gate
units, depending on whether the active trace is in the Time Domain or the
# ns
Distance Domain. In time domain, the units are in seconds (s),
milliseconds (ms), microseconds (µs), nanoseconds (ns), or
Center Gate
picoseconds (ps). In distance domain, the units are in meters (m),
# ns
centimeters (cm), or millimeters (mm). If the
Mode)"
Span Gate
settings are in feet (ft) only.
# ns
Gate Notch
On Off: Press this soft key to turn On or Off the Gate Notch feature. When
Gate Notch
Gate Notch is set to OFF, the polarity of the Gate is set to keep everything
On Off
between start and stop. When the Gate Notch is set to ON, the polarity of the
Gate is set to reject everything between start and stop.
Gate Shape
Gate Shape: Press this soft key to open the
Minimum
Shape value is displayed on the key face, and may be Minimum, Nominal,
Wide, or Maximum.
Back
Back: Press this soft key to return to the previous menu.
Figure 6-15. Gate Setup Menu (continued)
6-16
menu is used to set units in feet rather than meters, then the distance
menu is used to set units in feet rather than meters, then the distance
PN: 10580-00289 Rev. K
VNA View Menus
"Application Options Menu (VNA
"Application Options Menu (VNA
"Gate Shape Menu". The Gate
Vector Network Analyzer MG