Measure Menu – Dual - Anritsu MS2024B Manual

7-7 Measure Menus
Measure Menu – Dual
Display Type: Press this soft key to open the Display Type list box and
Measure
choose a display type. The choices are:
Display Type
Single, Dual, Overlay.
Dual
Active Display
TR1 TR2: Press this soft key to toggle the active display to Trace 1 or
Active Display
Trace 2.
TR1 TR2
Measurement Type: Press this soft key to open the Graph Type Selector list
Measurement Type
box and choose a graph type. Refer to the list in
Selector List Box" on page
Cable Loss
1-Port Smith, which is one of the measurement types in the list box.
IFBW
IFBW: Press this soft key to open a list box and set the Intermediate
Frequency bandwidth. The default is 10 kHz for the MS20xxC series
10kHz 1kHz 10Hz
instruments and 1 kHz for the MS20xxB and S412E series instruments.
Select 10 Hz for the maximum dynamic range; select 100 kHz for the
maximum speed.
Figure 7-17. Field View Measure Menu – Dual
Measure Menu – Overlay
Display Type: Press this soft key to open the Display Type list box and
Measure
choose a display type. The choices are:
Display Type
Single, Dual, Overlay.
Overlay
Active Display
Active Display Top Bottom: Press this soft key to toggle the active display to Top or
Bottom.
Top Bottom
Note: The Measurement Type soft key is not displayed because the Overlay
display type always presents Insertion Loss as Trace 1 and Return Loss as
Trace 2.
IFBW: Press this soft key to open a list box and set the Intermediate
IFBW
Frequency bandwidth. The default is 10 kHz for the MS20xxC series
instruments and 1 kHz for the MS20xxB and S412E series instruments.
10kHz 1kHz 10Hz
Select 10 Hz for the maximum dynamic range; select 100 kHz for the
maximum speed.
Figure 7-18. Field View Measure Menu – Overlay
7-16
5-4. The soft key in this illustration is displaying
PN: 10580-00289 Rev. K
Field View Menus
Section 5-4 "Graph Type
Vector Network Analyzer MG