Ricoh B286 Service Manual page 311

16 Plain: Low temp.Mode
1936 Lower Limit Temp: Press Roller
This SP sets the minimum difference allowed between the actual temperature
and the target temperature of the pressure roller.
! If the setting for the target temperature of the pressure roller is high
(SP1932), the temperature of the pressure roller is lowered for
continuous printing on plain paper.
At this time, if the temperature is below the temperature set for the
!
pressure roller, paper feed will stop during a long job to perform
inching to allow enough time for the pressure roller temperature to
rise to the level of the prescribed setting, and then the job will
continue.
Important:
! Modes "1" to "5" below refer to the paper and thickness settings
selected in User Tools (see "Paper Thickness Default Selection" in
this section).
! In order for this SP to operate, SP9952-1 must be at "0" (default) so
that the machine can acquire temperature readings (feedback) from
the pressure roller thermistors. SP9952 should never be adjusted in
the field.
1 Plain: Mode1
2 Plain: Mode2
3 Plain: Mode3
4 Plain: Mode4
5 Plain: Mode5
6 Trans.: Mode1
7 Trans.: Mode2
8 Trans.: Mode3
9 Trans.: Mode4
SM
[0 to 50/0/5]
o
[0 to 50/20/5 C]
o
[0 to 50/0/5 C]
o
[0 to 50/20/5 C]
5-41
SP1-xxx Feed
B286/B289