Toner Hopper Cover; Idle Registration Roller Panel - Ricoh B286 Service Manual

3.1.8 TONER HOPPER COVER

1. Side covers. (See section 3.12 "Side Covers.")
2. Toner hopper cover [A].
Reinstallation
! Make sure that the bent edge of the mylar [B] is attached around the edge of the plate.

3.1.9 IDLE REGISTRATION ROLLER PANEL

1. Open the upper unit.
2. Side covers. (See section 3.1.2 "Side Covers.")
3. Toner hopper cover (See section 3.18 "Toner Hopper Cover.")
Disconnect the connector and ground wire [A] (# x 1, " x 1).
4.
5. Idle registration roller panel [B] (" x 2)
! Remove the two rear screws [C] first and let the panel come down. Use a very
SM 3-7
Common Procedures
B286/B289