Paper Exit
Copy Exit Lever Down ("Upper" Selection Not Allowed)
!
The paper exit selection sensor [3] detects the lever in the "Lower" (down) position.
!
The operator must select "Lower" under "Copy Output Location" on the operation panel
display. If the operator selects "Upper" with the lever down, the machine will display a
message:
Cannot output to the selected location
Switch copy exit switching lever or paper output location
!
After the operator selects "Lower", the operation sequence is the same as that
described above (with the lever up and "Lower" selected).
Keep the copy exit selection lever in the vertical position for normal operation. This allows
the operator to select the copy output destination on the operation panel.
6.10.3 PAPER EXIT DRIVE
See Section 6.9.7 "Fusing Unit Drive Mechanism."
B286/B289
6-86
SM