Table of Contents
Advertisement
Common Procedures
short screwdriver to remove the rear screws.
!
Disconnect the panel from the stud screw on the right side first [D], then the left
side. Do not remove the stud screws.
3.1.10 MANUAL FEED TABLE, ORIGINAL FEED SENSOR
COVER
1.
Unlock and lift the original feed unit. (See section 3.1.5 "Unlocking, Opening the
Original Unit.")
2.
Open the upper unit.
3.
Side covers (See section 3.1.2 "Side Covers.")
4.
Manual feed table [A] (" x 2)
5.
Original feed sensor cover [B] (" x 2)
Reinstallation
!
Make sure that the mylar [C] is on the front edge of the exposure glass.
B286/B289
3-8
SM
Advertisement
Table of Contents
Troubleshooting
