Ricoh B286 Service Manual page 48

Main Machine Installation (B286)
10. Install the studs [1] on the right side and the left side.
! You must fasten each stud in the upper hole [2] on both sides.
11. Attach the right joint bracket [1] (the spindle [2] must go through the hole). At the same
time, align the plate with the holes for the three screws (blue).
! The joint brackets and screws are provided as accessories with either the Roll
Feeder (B851/B852) or Table (B854).
12. Attach screws
13. While you lift the main machine by its handle [3], set screw
keyhole cutout and tighten it.
14. Tighten screws
B286/B289
, but do not tighten them.
and .
1-12
in the lower hole of the
SM