Ricoh B286 Service Manual page 87

1. Attach the right joint bracket [1] (the spindle [2] must go through the hole). At the same
time, align the plate with the holes for the three screws (blue).
2. Attach screws ,
3. While you lift the main machine by its handle [3], set screw
keyhole cutout and tighten it.
4. Tighten screws ,
5. Do the above procedure again for the left joint bracket.
6. Reattach the manual feed table (" x 2).
7. Reattach the left and right covers (" x 3 each)
! Make sure that you attach the longer screws with the fine threads at the rear
sides of the covers.
8. Close the upper unit.
9. Clean the rear plate [1] of the table with alcohol.
10. Attach the harness clamp [2].
11. Clamp the power cord [3] to the table (" x 1).
SM
but do not tighten them.
.
1-51
Table (B854)
in the lower hole of the
B286/B289