Cis Adjustment With Sp Codes; To Print The Cis Adjustment Pattern - Ricoh B286 Service Manual

SP Adjustments
5. Do SP4961-3 to check the original scan length.
6. If the display is different, adjust with SP4961-1.
7. Do SP4961-2.
8. Touch "COPY Window" and scan the 1000 mm sheet that you prepared in Step 1.
9. Touch "SP Mode" to go back to the SP mode.
10. Do SP4961-3 to check the scan length.
11. If the display is different, adjust with SP4961-2.
Cut Length (mm)
Less than 297
to 594
to 841
to 1189
to 2000
to 3000
to 3600

3.11.2 CIS ADJUSTMENT WITH SP CODES

To Print the CIS Adjustment Pattern

1. Open the roll feeder drawer and cut off a sheet manually from a roll. (Turn the manual
feed knob to feed the paper, then push the cutter from side to side to cut.)
2. Close the roll feeder drawer.
3. Go into the "Copy SP" mode.
4. Do SP2902-2, select Pattern 11, then touch "OK."
5. Touch "COPY Window" to go to the main screen.
6. On the operation panel, select one of the rolls for paper feed.
7. Put the blank sheet of paper on the original feed tray and feed it into the original feed
unit. Pattern 11 (grid pattern) prints.
8. Touch "SP Mode" to return to the SP mode.
9. Open SP4973, push [1] on the operation panel to change the setting from "0" to "1",
then push [#]
B286/B289
Cut Tolerance (mm)
±4.50
±5.00
±6.00
±8.50
±18.0
±27.0
±33.0
3-78 SM