Ricoh B286 Service Manual page 412

SP5-xxx Mode
Addr Book Migration (SD -> HDD)
This SP moves the address book data from an SD card to the HDD. You must
turn the machine power off and on after executing this SP.
1. Turn the machine off.
2. Install the HDD.
3. Insert the SD card with the address book data in SD card Slot C3.
4. Turn the machine on.
5. Do SP5846-40.
6. Turn the machine off.
40
7. Remove the SD card from SD card Slot C3.
8. Turn the machine on.
Notes:
! Executing this SP overwrites any address book data already on the HDD
with the data from the SD card.
! We recommend that you back up all directory information to an SD card with
SP5846-51 before you execute this SP.
! After the address book data is copied to HDD, all the address book data is
deleted from the source SD card. If the operation fails, the data is not erased
from the SD card.
Fill Addr Acl Info.
This SP must be executed immediately after installation of an HDD unit in a
basic machine that previously had no HDD. The first time the machine is
powered on with the new HDD installed, the system automatically takes the
address book from the NVRAM and writes it to the new HDD. However, the new
address book on the HDD can be accessed only by the system administrator at
this stage. Executing this SP by the service technician immediately after power
41
on grants full address book access to all users.
Procedure
1. Turn the machine off.
2. Install the new HDD.
3. Turn the machine on.
4. The address book and its initial data are created on the HDD automatically.
However, at this point the address book can be accessed by only the
B286/B289 5-142 SM