Table of Contents
Advertisement
2.
Disconnect the cables of the standard Ethernet board and standard USB board.
3.
Cover the standard connection points with the caps to prevent accidental reconnection
of the standard cables.
4.
Remove the cover of Slot B [1] (" x 2).
Insert the Gigabit Ethernet Board [2] into Slot B (Knob " x 2).
5.
6.
Attach the ferrite core provided with the Gigabit Ethernet Board to the end of the cable
[1] to be attached to the network.
7.
Attach the ferrite core provided with the main machine to the end of the cable [2] to be
attached to the main machine.
!
Attach both cores 4.5 cm (about 2 in.) from each end of the cord.
8.
Reconnect the machine to its power source and turn the main power switch on.
9.
Do SP5985-2 and set to "1" to enable the NIC and USB functions.
SM
Installation of MFP Options
1-71
B286/B289
Advertisement
Table of Contents
Troubleshooting
