Installing The Ide Power Cable; Figure 14-14 Connecting The Ide Power Cable To The Optical Drive - Sun Microsystems Blade 1500 Service, Diagnostics, And Troubleshooting Manual

Proceed to
Note – The optical drive and hard drive(s) do not operate without the IDE power
cable.
14.4.3

Installing the IDE Power Cable

1. Power off the system and open the chassis.
Refer to:
"Powering Off the Workstation" on page 10-4
■
"Removing the Access Panel" on page 10-12
■
2. Locate where the IDE power cable is to be installed.
See
FIGURE 14-11
3. Connect the center connector of the IDE power cable to the motherboard
at IDE PWR.
The center connector is at the vertex of the Y. See
4. Connect the branch of the IDE power cable with the solitary connector to the
optical drive.
See
FIGURE 14-14
Optical
drive
FIGURE 14-14
5. Attach the other branch end connector to the upper hard drive HDD0.
See
FIGURE 14-15
14-16 Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004
"Installing the IDE Power Cable" on page
.
.
Interface cable
Connecting the IDE Power Cable to the Optical Drive
.
14-16.
and
FIGURE 14-1 FIGURE 14-15
IDE power cable
.