Replacing The Power Supply; Identifying The Power Supply; Figure 13-1 Power Supply Location And Identification - Sun Microsystems Blade 1500 Service, Diagnostics, And Troubleshooting Manual

Caution – When servicing or removing workstation components, attach an
antistatic strap to your wrist and then to a metal area on the chassis. Then disconnect
the power cord from the workstation and the wall receptacle. Following this caution
equalizes all electrical potentials with the workstation.
13.1

Replacing the Power Supply

This section describes removal and installation of the power supply. Topics include:
"Identifying the Power Supply" on page 13-2
■
"Removing the Power Supply" on page 13-3
■
"Installing the Power Supply" on page 13-5
■
13.1.1

Identifying the Power Supply

The power supply is required for workstation operation. Power supply cables are
directly connected to the motherboard. The power supply provides an IEC-320
power cord connector at the rear of the chassis. See
IEC-320
connector
Power
supply fan
FIGURE 13-1
13-2 Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004
Click this film icon to view an animated version of these instructions.
Power Supply Location and Identification
.
FIGURE 13-1
Connector PS2
Connector PS1
Connector PS0