Sun Microsystems Blade 1500 Service, Diagnostics, And Troubleshooting Manual page 380

Connector J24 SW0
FIGURE 14-18
6. Squeeze the tabs on either side of the power switch assembly and tilt it out and
away from the front panel.
See
FIGURE 14-18
7. Lift the power switch assembly up and away from the chassis.
8. Feed the power switch assembly cable through the opening in the front panel as
you lift away the power switch assembly.
See
FIGURE 14-18
Proceed to
Note – The workstation does not operate without the power switch assembly.
14-20 Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004
Removing the Power Switch Assembly
.
.
"Installing the Power Switch Assembly" on page
Rectangular hole
14-21.