Removing The Power Supply - Sun Microsystems Blade 1500 Service, Diagnostics, And Troubleshooting Manual

TABLE 13-1
TABLE 13-1
Specification
Input Voltage
Frequency
Current
Wattage
13.1.2

Removing the Power Supply

1. Power off the system, open and position the chassis.
Refer to:
"Powering Off the Workstation" on page 10-4
■
"Removing the Access Panel" on page 10-12
■
"Positioning the Chassis" on page 10-16
■
2. Locate the power supply.
The power supply is fastened to the rear panel of the workstation chassis. See
FIGURE 13-1
3. Release the cables out of the power supply cable routing clips.
See
FIGURE 13-2
lists the power supply specifications.
Power Supply Specifications
Value
100 - 240 VAC
50 - 60 Hz
8 amp, 4 amp
420 W maximum
.
.
Chapter 13 Replacing Chassis Components 13-3