FIGURE 14-4
5. Install the smart card reader bracket.
Refer to
6. Inspect the cabling to verify that:
The interface cable is routed correctly through the reader cable clip, with a
■
minimum of kinks.
The interface cable is secure in the smart card reader connector.
■
The interface cable is secure in the motherboard connector SCR0.
■
7. Install the bezel, the access panel, power on the system, and verify the smart card
reader cable installation.
Refer to:
"Installing the Bezel" on page 15-2
■
"Installing the Access Panel" on page 15-5
■
"Powering On the Workstation" on page 15-8
■
"Verifying an Installation" on page 15-11
■
14.2
Replacing the Optical Drive Interface
Cable
This section describes removal and installation of the optical drive interface cables.
Topics include:
"Identifying the Optical Drive Interface Cable" on page 14-7
■
"Removing the Optical Drive Interface Cable" on page 14-7
■
"Installing the Optical Drive Interface Cable" on page 14-8
■
14-6
Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004
Smart card reader
interface cable
Cable connection
Connecting the Cable to the Smart Card Reader
Step 7
of
"Installing the Smart Card Reader" on page
12-20.