Replacing The Pci Cards; Figure 11-30 Installing The Nvram - Sun Microsystems Blade 1500 Service, Diagnostics, And Troubleshooting Manual

FIGURE 11-30
4. Press the NVRAM down until snug.
5. Make sure the NVRAM is tight in its connector.
6. If you removed the PCI cards prior to replacing the NVRAM, install the PCI cards.
Refer to
7. Choose your next step:
If you installed the NVRAM after installing a new motherboard, return to
■
of
Otherwise, reposition the chassis, install the access panel, power on the system,
■
and verify the NVRAM installation.
Refer to:
■
■
■
■
11.5

Replacing the PCI Cards

This section describes removal and installation of PCI cards in the workstation.
Topics include:
"Identifying the PCI Cards" on page 11-29
■
"Removing a PCI Card" on page 11-30
■
"General PCI Card Guidelines" on page 11-33
■
"Special Considerations for Graphics Accelerators" on page 11-34
■
11-28 Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004
Installing the NVRAM
"Installing a PCI Card" on page
"Installing the Motherboard" on page
"Repositioning the Chassis" on page 15-1
"Installing the Access Panel" on page 15-5
"Powering On the Workstation" on page 15-8
"Verifying an Installation" on page 15-11
NVRAM key
NVRAM connector key
11-38.
11-50.
Step 15