Replacing Storage Devices - Sun Microsystems Blade 1500 Service, Diagnostics, And Troubleshooting Manual

12
C H A P T E R

Replacing Storage Devices

This chapter describes the remove and install procedures for the Sun Blade 1500
workstation storage devices.
The procedures described in this chapter are written for workstation service
providers and system administrators.
This chapter contains the following topics:
"Replacing a Hard Drive" on page 12-2
■
"Replacing the Optical Drive" on page 12-9
■
"Replacing the Smart Card Reader" on page 12-15
■
Caution – To prevent equipment damage, review the safety requirements, safety
symbols, and safety precautions in
before you perform any replacement procedure. Additional cautions, warnings, and
instructions are provided in the Sun Blade 1500 Safety and Compliance Guide
The document is available from:
http://www.sun.com/documentation.
Caution – The procedures in this chapter are performed with the workstation
chassis in an upright position. Use care that you do not tip over the chassis.
Caution – When servicing or removing workstation components, attach an
antistatic strap to your wrist and then to a metal area on the chassis. Then disconnect
the power cord from the workstation and the wall receptacle. Following this caution
equalizes all electrical potentials with the workstation.
"Preparing to Replace Components" on page 10-1
817-5130.
,
12-1