FIGURE 13-46
8. Inspect the speaker fasteners to verify that:
The speaker is secure in the bracket.
■
The speaker bracket tabs are well seated in the chassis.
■
9. Inspect the speaker cabling to verify that:
The speaker cable is firmly connected to the motherboard at SPK0.
■
The speaker cable is routed through the bezel cable clip.
■
The bezel cable clip is closed and locked.
■
10. Install the bezel, the access panel, power on the system, and verify the speaker
installation.
Refer to:
"Installing the Bezel" on page 15-2
■
"Installing the Access Panel" on page 15-5
■
"Powering On the Workstation" on page 15-8
■
"Verifying an Installation" on page 15-11
■
13-44
Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004
SPK0
Securing the Speaker Cable in the Bezel Cable Clip
Bezel cable clip