9. Guide the audio USB board cables through the I/O cable clip at the bottom of the
chassis and close the clip.
See
FIGURE 13-41
FIGURE 13-41
10. Inspect the audio USB board fasteners to verify that:
The audio USB board to bracket screws are tight
■
The audio USB assembly to chassis screws are tight.
■
11. Inspect the audio USB board cabling to verify that:
The audio cable is firmly connected to the audio USB board and to the
■
motherboard at J13 AUDIO.
The USB cable is firmly connected to the audio USB board and to the
■
motherboard at J19 USB.
The I/O cable clip is closed and locked.
■
12. Install the bezel, the access panel, power on the system, and verify the audio USB
board installation.
Refer to:
13-38
Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004
.
J19 USB
J13 Audio
Securing the Audio USB Cables in the I/O Cable Clip
I/O cable clip