Cable Assemblies; Removing The Peripheral Power Cable Assembly - Sun Microsystems Sun Ultra 30 Service Manual

1. Replace the SCSI drive bay as follows (
a. Position the SCSI drive bay on the channel slides and slide it in.
b. Using a number 2 Phillips screwdriver, replace the screws securing the SCSI
drive bay to the chassis.
c. Connect the SCSI cables to the motherboard connectors.
d. Press the SCSI cables into the cage hole and beneath the PCI fan assembly.
e. Replace the peripheral power cable into the cable routing clips.
f. Replace the diskette drive cable into the plastic spring clips installed adjacent
to the drive bay.
g. Replace the hard drive(s).
See Section 9.1.2 "Replacing a Hard Drive" on page 9-3.
Note – Hooks at the chassis base must lock into the bottom holes of the drive
bracket.
2. Connect the AC power cord.
3. Detach the wrist strap.
4. Replace the side access cover.
See Section 7.3 "Replacing the Side Access Cover" on page 7-5.
5. Power on the system unit.
See Section 6.1 "Powering On the System Unit" on page 6-1.
8.4

Cable Assemblies

To remove and replace the peripheral power cable assembly, the diskette drive cable
assembly, or the M6-type UPA graphics card cable assembly, proceed as follows.
8.4.1

Removing the Peripheral Power Cable Assembly

1. Power off the system unit.
See Section 6.2 "Powering Off the System Unit" on page 6-3.
-10 Sun Ultra 30 Service Manual • April 1998
):
FIGURE 8-4