14.1.1
Identifying the Smart Card Reader Cable
The smart card cable connects the smart card reader to the motherboard at SCR0. It
is a 10-conductor ribbon cable.
connections.
FIGURE 14-2
14.1.2
Removing the Smart Card Reader Cable
1. Power off the system, open the chassis, and remove the bezel.
Refer to:
"Powering Off the Workstation" on page 10-4
■
"Removing the Access Panel" on page 10-12
■
"Removing the Bezel" on page 10-14
■
2. Remove the smart card reader bracket.
Refer to
card reader from the bracket.
3. Pull the interface cable from the connector on the smart card reader.
See
FIGURE 14-3
14-4
Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004
Smart card reader
Smart Card Reader Cable Connection
"Removing the Smart Card Reader" on page
. Set the cable aside.
shows the smart card reader cable
FIGURE 14-2
Connector
SCR0
12-16. Do not remove the smart