FIGURE 13-51
6. Inspect the PCI card support fasteners to verify that:
The PCI card support is snug between the chassis cross brace and the chassis.
■
The chassis cross brace is fastened tight to the chassis.
■
The PCI card support fingers are snug against each respective PCI card.
■
7. Choose your next step:
If you installed the PCI card support after installing the motherboard, return to
■
Step 19
Otherwise, install the access panel and power on the system. Refer to:
■
■
■
13.8
Replacing the Chassis Cross Brace
This section describes removal and installation of the chassis cross brace. Topics
include:
"Identifying the Chassis Cross Brace" on page 13-50
■
"Removing the Chassis Cross Brace" on page 13-51
■
"Installing the Chassis Cross Brace" on page 13-53
■
Spring-loaded fingers (5)
Closing the PCI Card Support
of
"Installing the Motherboard" on page
"Installing the Access Panel" on page 15-5
"Powering On the Workstation" on page 15-8
11-50.
Chapter 13 Replacing Chassis Components
13-49