Installing The Power Switch Assembly; Figure 14-19 Routing The Power Switch Assembly Cable - Sun Microsystems Blade 1500 Service, Diagnostics, And Troubleshooting Manual

14.5.3

Installing the Power Switch Assembly

1. Open the chassis and remove the bezel.
Refer to:
"Removing the Access Panel" on page 10-12
■
"Removing the Bezel" on page 10-14
■
2. Locate where the power switch assembly is to be installed.
The power switch assembly mounts to the chassis front panel. It attaches to the front
fan grille and to the four holes above the grille. See
3. Remove the new power switch assembly from its packaging.
4. Route the power switch assembly cable routes through the rectangular hole in the
chassis front panel above the front fan, through the metal clamp, and through the
bezel cable clip.
See
FIGURE 14-19
Connector J24 SW0
FIGURE 14-19
and
FIGURE 14-20
Routing the Power Switch Assembly Cable
FIGURE 14-16
.
Rectangular hole
Chapter 14 Replacing Internal Cables
.
14-21