"Positioning the Chassis" on page 10-16
■
2. Identify the battery installation site, BAT0.
See
FIGURE 11-25
3. Position the battery over the battery socket with the plus (+) side up.
4. Press the battery down into the socket until it clicks into place.
See
FIGURE 11-27
FIGURE 11-27
5. Make sure the battery is tight in its socket.
6. Reposition the chassis, install the access panel, power on the system, and verify
the battery installation.
Refer to:
"Repositioning the Chassis" on page 15-1
■
"Installing the Access Panel" on page 15-5
■
"Powering On the Workstation" on page 15-8
■
"Verifying an Installation" on page 15-11
■
11.4
Replacing the NVRAM
This section describes removal and installation of the nonvolatile random access
memory (NVRAM). Topics include:
"Identifying the NVRAM" on page 11-26
■
.
.
Installing the Battery
Chapter 11 Replacing the Motherboard and Associated Components
11-25