Figure 14-20 Securing The Power Switch Assembly Cable To The Bezel Cable Clip And Metal Clamp - Sun Microsystems Blade 1500 Service, Diagnostics, And Troubleshooting Manual

5. Connect the cable to the motherboard at J24 SW0.
See
FIGURE 14-19
6. Hook the two lower feet of the power switch assembly into the third and fourth
holes in the second row of the front fan grille.
7. Rock the power switch assembly back to snap the two upper feet and tabs into the
four holes.
Make sure the power switch assembly is fully seated against the chassis front panel.
See
FIGURE 14-19
8. Secure the power switch assembly cable to the metal clamp and bezel cable clip.
See
FIGURE 14-20
FIGURE 14-20
9. Check that the power switch assembly bracket feet are well seated in the chassis.
10. Inspect the power switch assembly cabling to verify that:
The power switch assembly cable is firmly connected to the motherboard
■
at J24 SW0.
14-22 Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004
and
FIGURE 14-20
.
.
Bezel cable clip
J24 SW0
Securing the Power Switch Assembly Cable to the Bezel Cable Clip and
Metal Clamp
.
Metal clamp