Removing A Pci Card; Figure 11-32 Swinging Out The Pci Card Support - Sun Microsystems Blade 1500 Service, Diagnostics, And Troubleshooting Manual

11.5.2

Removing a PCI Card

1. Power off the system, open and position the chassis.
Refer to:
"Powering Off the Workstation" on page 10-4
■
"Removing the Access Panel" on page 10-12
■
"Positioning the Chassis" on page 10-16
■
2. Locate the PCI card you wish to remove.
If the PCI card is located in slot PCI4, remove the chassis cross brace according to
the procedure in
3. If necessary, squeeze the inside tabs together and swing the PCI card support out.
See
FIGURE 11-32
FIGURE 11-32
4. Using a No. 2 Phillips screwdriver, remove the screw that secures the PCI card
retainer to the chassis rear panel.
See
FIGURE 11-33
5. Unlatch the PCI card retainer and lift it up.
See
FIGURE 11-33
11-30 Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004
"Removing the Chassis Cross Brace" on page
.
Swinging Out the PCI Card Support
. Set the screw aside in a container.
.
13-51.
Inside tabs