Figure 11-12 Sliding The Duct Down - Sun Microsystems Blade 1500 Service, Diagnostics, And Troubleshooting Manual

Note – If the ejector levers are not in the closed position, the DIMM cooling duct
binds when slid down.
10. While maintaining a light pressure towards the rear fan bracket, slide the duct
down.
See .
FIGURE 11-12
Sliding the Duct Down
FIGURE 11-12
11. Press the duct down until the catch clicks it into place.
12. If you returned the DIMM cooling duct to its original position after installing the
CPU fan and heat sink assembly, return to
Heat Sink Assembly" on page
13. Inspect the DIMM and other component fasteners to verify that:
The DIMM ejectors are upright and tight.
■
If removed, verify the rear fan bracket feet are well seated in the chassis.
■
14. Inspect the DIMM and other component cabling to verify that:
The DIMM is fully seated in the slot.
■
If removed, verify the rear fan cable is firmly connected to the motherboard.
■
15. Choose your next step:
If you installed DIMMs after installing the motherboard, return to
■
"Installing the Motherboard" on page
11-18.
Chapter 11 Replacing the Motherboard and Associated Components
Step 11 of "Installing the CPU Fan and
11-50.
Step 16 of
11-11