8. Continue to slide the duct to the right until the catch on the rear fan bracket
clicks.
See
FIGURE 13-32
FIGURE 13-32
9. Inspect the DIMM cooling duct to verify that:
The duct covers the DIMMs and is not in a bind with the DIMMs.
■
The guide rails of the duct are matched with the guide rails of the rear fan
■
bracket.
10. Choose your next step:
If you installed the DIMM cooling duct after installing the rear fan, return to
■
Step 8
If you installed the DIMM cooling duct after installing the motherboard, return to
■
Step 18
Otherwise, install the access panel and power on the system. Refer to:
■
■
■
13.5
Replacing the Audio USB Board
This section describes removal and installation of the audio and USB card. Topics
include:
13-30
Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004
.
Duct Clicks Into Place
of
"Installing the Rear Fan" on page
of
"Installing the Motherboard" on page
"Installing the Access Panel" on page 15-5
"Powering On the Workstation" on page 15-8
13-18.
11-50.