Figure 12-15 Disconnecting The Smart Card Reader Interface Cable - Sun Microsystems Blade 1500 Service, Diagnostics, And Troubleshooting Manual

Connector SCR0
Disconnecting the Smart Card Reader Interface Cable
FIGURE 12-15
Note – Do not remove the cable from the rear of the smart card reader.
5. Squeeze together the two green plastic tabs of the drive rails and pull the smart
card reader bracket, with its cable attached, straight out of the removable media
bay.
See . Set the smart card reader bracket down on an antistatic mat.
FIGURE 12-16
12-18 Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004