Removing The Diskette Drive Power Cable Assembly; Figure 6-3 Removing And Replacing The Diskette Drive Power Cable Assembly - Sun Microsystems Sun Blade 150 Service Manual

6.2.3 Removing the Diskette Drive Power Cable
Assembly
1. Power off the system, remove the system cover, and attach an antistatic wrist strap
as described in Chapter 5.
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
2. Remove the diskette drive power cable assembly connectors from the following
(
FIGURE 6-3
Diskette drive
I
Riser board (J10)
I
3. Open the two cable routing clips (
4. Remove the diskette drive power cable assembly from the chassis.
Note – You can move the fan assembly for easier access to the cables. See
Section 6.4.1, "Removing the Fan Assembly" on page 6-15.
Diskette drive power cable
Cable routing clip
J10 connector
FIGURE 6-3
):
Removing and Replacing the Diskette Drive Power Cable Assembly
Chapter 6 Removing and Replacing Major Subassemblies
).
FIGURE 6-3
6-5