Figure 12-5 Removing The Drive Rails From Storage - Sun Microsystems Blade 1500 Service, Diagnostics, And Troubleshooting Manual

Note – If you are installing an additional hard drive, it might be installed in the
remaining free slot in the hard drive bracket. The hard drive that you want to use to
boot the system must be installed in slot HDD0, the slot closest to the top of the
chassis.
3. Remove the new hard drive from its packaging.
4. Remove the spare drive rails from their storage position, if needed.
The drive rails are stored on the underside of the hard drive bay. Remove them from
their storage location. See
Removing the Drive Rails From Storage
FIGURE 12-5
5. Snap both drive rails into the holes on both sides of the hard drive.
The lettering on the drive rails (HDD-L and HDD-R) is upright and the drive rail tabs
are toward the hard drive power and interface connectors. See
.
FIGURE 12-5
Chapter 12 Replacing Storage Devices
Drive rails on
underside
FIGURE 12-6
.
12-7