Cable Assemblies; Removing The Peripheral Power Cable Assembly - Sun Microsystems Ultra 80 Service Manual

3. Replace the access panel and power on the system.
See Section 6.3 "Replacing the Access Panel/Powering On the System" on page 6-6.
7.4

Cable Assemblies

Use the following procedures to remove and replace the peripheral power cable
assembly, the diskette drive cable assembly, and the combined cable assembly.
Note – Unconnected portions of the peripheral power cable assembly should
remain clipped inside the chassis.
7.4.1

Removing the Peripheral Power Cable Assembly

1. Power off the system and remove the access panel.
See Section 6.1 "Powering Off the System/Removing the Access Panel" on page 6-1.
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
2. Attach the antistatic wrist strap.
See Section 6.2 "Attaching the Antistatic Wrist Strap" on page 6-5.
3. Disconnect the peripheral power cable assembly as follows (
a. Disconnect the peripheral power cable assembly connector from connector
J4112 on the motherboard.
b. Disconnect the peripheral power cable assembly from the chassis clips.
c. Disconnect the peripheral power cable assembly connectors from the CD-ROM
drive, the hard drive cage, and the diskette drive.
4. Lift the peripheral power cable assembly up and out of the chassis.
):
FIGURE 7-5
Chapter -9