Installing The Audio Usb Board; Figure 13-37 Removing The Audio Usb Board From The Bracket - Sun Microsystems Blade 1500 Service, Diagnostics, And Troubleshooting Manual

FIGURE 13-37
8. Set the audio USB board on an antistatic mat. Set the bracket aside.
Proceed to
Note – Do not operate the workstation without the audio USB board installed.
13.5.3

Installing the Audio USB Board

1. Open the chassis and remove the bezel.
Refer to:
"Removing the Access Panel" on page 10-12
■
"Removing the Bezel" on page 10-14
■
2. Position the bracket on an antistatic mat with the two arms facing up.
3. Remove the audio USB board from its packaging.
4. Slide the audio USB board into the audio USB board bracket with components
facing up.
See
FIGURE 13-38
Audio USB board
bracket
Screws
Removing the Audio USB Board From the Bracket
"Installing the Audio USB Board" on page
.
Audio USB board
13-35.
Chapter 13 Replacing Chassis Components 13-35