Sun Microsystems Blade 1500 Service, Diagnostics, And Troubleshooting Manual page 191

Subsequent Steps to Test Components in Connection Mode (Continued)
TABLE 9-1
Component Steps to Take
Network 6. Select Network.
7. Click Reset.
8. Click Start.
Serial ports 6. Select Comm. Ports.
7. Click Reset.
8. Click Start.
Parallel 6. Click the plus sign adjacent to
Other Devices.
port
7. Select ecpp0(eccptest).
8. Click Reset.
9. Click Start.
Speaker 6. Click the plus sign adjacent to
Other Devices.
7. Select sound0(audiotest).
8. Click Reset.
9. Click Start.
System 6. Click the plus sign adjacent to
Other Devices.
sensors
7. Select adm1031(env3test).
8. Click Reset.
9. Click Start.
Successful Test Results
Connection test starting....
Connection test complete
Comm.Ports
su0
Status: Idle:
/dev/term/a:
Idle, current baud = 9600, maximum baud = 115200,
/dev/term/b:
Connection test complete
Connection test starting....
OtherDevices
ecpp0
Status: Idle:
/dev/ecpp0:
1284 compliant device mode - Centronics only)
Connection test complete
Connection test starting....
audio: Playing 2 second(s) 1 KHz tone through the speaker
port...Connection test complete
done.
sound0
Status: Idle:
/dev/sound/0:
AC97 Codec, 16-bit Stereo, 48 KHz sample rate
Connection test starting....
adm1031
Status: Found
cpu-fan (fan. 460000053e)
intake-fan (fan. 4600000544)
outtake-fan (fan. 460000054a)
cpu (temperature-sensor. 460000051d)
int-amb (temperature-sensor. 4600000528)
sys-in (temperature-sensor. 4600000533)
Connection test complete
IEEE 1284 parallel port,
Port mode = ECPP_CENTRONICS (non-IEEE
Chapter 9 SunVTS 9-5